Random image

33-0664m.jpg

CARB REBUILD

  • I had lots of trouble getting the unit off the bike! I suspect what the manuals says about; "...just unbolt the manifold

    • I had lots of t…

  • Carefull ! with the threads. The carb-body is made of a rather soft nickel-alloy, and several of the threads on mine was in a re

    • Carefull ! with…

  • This spring can so easily go:..SPOOOOING

    • This spring can…

  • Silly me! I thought these pins was part of the body. They're not. So don't loose them. I did loose one. Made one up by cutting a

    • Silly me! I tho…

  • Interesting! This is the vacuum chamber cover for the carb that goes on cylinder "1". It has a "1" prefix.

    • Interesting! Th…

  • Corresponding "1" prefix in floatbowl for carb that goes on cylinder "1". The other tree has prefix "2

    • Corresponding &…

  • Here's a set-up for adjusting float-level, if you do not release the carbs from the plenum. Adjust "tilt-level" of ca

    • Here's a s…

  • This is the "tang" where the float height adjustment is made ...carefully!

    • This is the &qu…

  • The lines of the edge of the float should be parallel to the carb-body-edge. NOTE: The Clymer Manual has got the adjustment

    • The lines of th…

  • ...and must measure exactly 21mm, from the RAISED 'LIP' of the carb body Remember; this goes for both the floats of each carb.

    • ...and must mea…

  • Keep your parts in order!!!!!!

    • Keep your parts…

  • No prize for guessing witch one had been fixed up, and witch hasn't.-)

    • No prize for gu…