Random image

trailer_chopper

GL1100I Work

Building a replacement regulator, rebuilding shocks, rewiring, and brake M/Cs and rear caliper rebuild

  • This yellow wire was corroded much more than the other two

    • This yellow wir…

  • Three new contacts soldered on harness and stator wires

    • Three new conta…

  • New connector, not an exact match so it fits differently

    • New connector,…

  • Removing contacts from regulator-rectifier plug to solder, pretty corroded around the crimp

    • Removing conta…

  • Cleaned up and soldered

    • Cleaned up and…

  • Side panel LED running-turn signal lights

    • Side panel LED…

  • Three pin connector to connect to running-turn signal lights circuit

    • Three pin conne…

  • These are connector cables for a computer, cut in half

    • These are conne…

  • Wires soldered to running-turn signal lights plug inside fairing

    • Wires soldered…

  • Wires run from fairing lights plug to lower panels, left side...

    • Wires run from…

  • and right side

    • and right side

  • Left side wires being wrapped

    • Left side wires…