Take a little jumper of wire and run it directly from the neg battery terminal to the Condensor housing. See if that does anything
Popping out exhaust
Moderators: CYBORG, Oldewing, robin1731, Forum Moderators
-
Whiskerfish
- President
- Posts: 37079
- Joined: Thu Feb 16, 2006 9:34 pm
- My Album: http://www.ngwclub.com/gallery/v/wingmans/whiskerfish/
- Location: Norfolk Va
Re: Popping out exhaust
"Agreement is not a requirement for Respect" CDR Michael Smith USN (Ret) 2017
"The book is wrong, this whole Conclusion is Fallacious" River Tam
"Yea I do dance awkwardly, and I am having more fun than you" Taylor Swift
2008 GL1800 IIIA "TH3DOG"
1984 GL1200 Standard
1975/6/7/8/9 Arthur Fulmer Dressed Road bike
1975 Naked Noisy and Nasty in town bike
Psst. oh and by the way CHANGE YOUR BELTS!!!!
"The book is wrong, this whole Conclusion is Fallacious" River Tam
"Yea I do dance awkwardly, and I am having more fun than you" Taylor Swift
2008 GL1800 IIIA "TH3DOG"
1984 GL1200 Standard
1975/6/7/8/9 Arthur Fulmer Dressed Road bike
1975 Naked Noisy and Nasty in town bike
Psst. oh and by the way CHANGE YOUR BELTS!!!!
-
tory
- Titanium Member
- Posts: 400
- Joined: Sat Oct 21, 2006 2:54 pm
- Location: Holland MI
Re: Popping out exhaust
Good tip. I did replace the condensor last week and made sure all grounds where good and clean. Both condensors whete new but i had to try. There is a ground from the condensor direct to battery neg.Whiskerfish wrote: ↑Sun May 05, 2024 8:03 pmTake a little jumper of wire and run it directly from the neg battery terminal to the Condensor housing. See if that does anythingtory wrote: ↑Sun May 05, 2024 7:48 pm Using MP08 coils and still point ignition.Keep me posted on your success.Whiskerfish wrote: ↑Sun May 05, 2024 8:03 pm Take a little jumper of wire and run it directly from the neg battery terminal to the Condensor housing. See if that does anything
1978 GL1000
1986 GL1200 Aspencade
With California Sidecar
1965 CA95 Benly
1986 GL1200 Aspencade
With California Sidecar
1965 CA95 Benly
-
tory
- Titanium Member
- Posts: 400
- Joined: Sat Oct 21, 2006 2:54 pm
- Location: Holland MI
Re: Popping out exhaust
Happy to report the popping is gone. Maybe it felt threatened watching me tear down the old set of carbs. Lol
Or the cleaning last week had a delayed reaction
Could be the short rides every chance I get burning a fresh tank of fuel through.
Whatever the case, I started it to warm the boots before pulling the carburetors back off, and noticed it had not popped even after warmed up. I readjusted the low speed jet, and it actually made a noticeable difference this time. I did the idle drop as WF recommended and went for a 20 mile ride. Never ran better, no pops, much smoother through 4200 RPM and cylinder #1 was up to normal Temps.
Or the cleaning last week had a delayed reaction
Could be the short rides every chance I get burning a fresh tank of fuel through.
Whatever the case, I started it to warm the boots before pulling the carburetors back off, and noticed it had not popped even after warmed up. I readjusted the low speed jet, and it actually made a noticeable difference this time. I did the idle drop as WF recommended and went for a 20 mile ride. Never ran better, no pops, much smoother through 4200 RPM and cylinder #1 was up to normal Temps.
- Attachments
-
- 20240511_162647.jpg (234.85 KiB) Viewed 146 times
Last edited by tory on Sun May 12, 2024 8:23 am, edited 1 time in total.
1978 GL1000
1986 GL1200 Aspencade
With California Sidecar
1965 CA95 Benly
1986 GL1200 Aspencade
With California Sidecar
1965 CA95 Benly
-
cfairweather
- Silver Member
- Posts: 716
- Joined: Sun Apr 13, 2014 10:37 pm
- Location: Cheyenne, Wyoming
Re: Popping out exhaust
Glad you got it solved. Now go for some long rides and enjoy it.
-
Fred Camper
- Vice President
- Posts: 6941
- Joined: Wed Aug 12, 2009 9:38 pm
- My Album: http://www.ngwclub.com/gallery/v/wingmans/Jeff+Bozeman/
- Location: Metro Detroit
- Contact:
Re: Popping out exhaust
Glad you got her out to the Holland Pier. That is what it takes to prove the problem is solved. Enjoy your ride.
Proud member of the NGW Cartel (Rochester MI)
1977 GL1000 BADDOG (April 2012 BOTM)
1976 LTD - '993 LTD...and so it begins'
You should remember that it's peace of mind you're after and not just fixing the machine. R.Pirsig
1977 GL1000 BADDOG (April 2012 BOTM)
1976 LTD - '993 LTD...and so it begins'
You should remember that it's peace of mind you're after and not just fixing the machine. R.Pirsig
-
Whiskerfish
- President
- Posts: 37079
- Joined: Thu Feb 16, 2006 9:34 pm
- My Album: http://www.ngwclub.com/gallery/v/wingmans/whiskerfish/
- Location: Norfolk Va
Re: Popping out exhaust
Fingers crossed
"Agreement is not a requirement for Respect" CDR Michael Smith USN (Ret) 2017
"The book is wrong, this whole Conclusion is Fallacious" River Tam
"Yea I do dance awkwardly, and I am having more fun than you" Taylor Swift
2008 GL1800 IIIA "TH3DOG"
1984 GL1200 Standard
1975/6/7/8/9 Arthur Fulmer Dressed Road bike
1975 Naked Noisy and Nasty in town bike
Psst. oh and by the way CHANGE YOUR BELTS!!!!
"The book is wrong, this whole Conclusion is Fallacious" River Tam
"Yea I do dance awkwardly, and I am having more fun than you" Taylor Swift
2008 GL1800 IIIA "TH3DOG"
1984 GL1200 Standard
1975/6/7/8/9 Arthur Fulmer Dressed Road bike
1975 Naked Noisy and Nasty in town bike
Psst. oh and by the way CHANGE YOUR BELTS!!!!
-
redglbx
- Gold Member
- Posts: 1179
- Joined: Tue Jun 02, 2020 8:39 am
- Location: NW Indiana,
Re: Popping out exhaust
Red 1976 oe owner
1976 LTD restored
1980 CBX , in the que, to fix the ignorant heavy handed owner
1981 CBX
1977 CB750 K7
2014 FJR OE owner, sold
1980 GL1100
1984 GL1200 naked
1969 CL350, in the que
1976 LTD restored
1980 CBX , in the que, to fix the ignorant heavy handed owner
1981 CBX
1977 CB750 K7
2014 FJR OE owner, sold
1980 GL1100
1984 GL1200 naked
1969 CL350, in the que
-
- Similar Topics
- Replies
- Views
- Last post