goldwing carburetors

[john]

found a page on the net that gave the cross referance for 1100 carbs. listed several other hondas that parts would fit 1100s. saved it somewhere but now can't fine where i put it. (like i always do) anyuone have this info. thanks John

[Try]

found a page on the net that gave the cross referance for 1100 carbs. listed several other hondas that parts would fit 1100s. saved it somewhere but now can't fine where i put it. (like i always do) anyuone have this info. thanks John

I know a lot of Honda's from '70 - '80 used identical carbs mounted
to different racks. Some of the carburetors was bigg and some was smaller,
but the design was the same.

Try newmotorcycleparts.com

[quakeholio]

cb900c uses the same from what i've seen, so dose the f and i think the 750.

If you want to hear people complain about carborators look on http://www.cb1100f.net. If you don't know the cb900 came in two flavors, C = cruser, f = sports bike.

I've wondered how much work it would be to fit different carbs to the gl family. Maybe it can't be done.

Maybe i better keep my trap shut on this one.

[Try]

I've wondered how much work it would be to fit different carbs to the gl family. Maybe it can't be done.

I think so, if you build a new rack...

Maybe i better keep my trap shut on this one.

LOL


I got an email with cross references from a gent, he is lurking
in our forum and send it to me. Thank you "Guest"

CM250C

CM400/450T '78-'81

CB450SC

CX500 C,D '78-'82

FT500 '82-'83

GL500

CB650 '81-'82

CX650

CB750 L,F,C,K,SC '79-'83

CB900 C,F

CBX

CB1000/1100

GL1100

[quakeholio]

i'm not supprised about the number of bikes the carbs made it onto. must have gotten a pretty good deal, if i'm thinking right that is most of honda models from late 70's to early 80's.

Thanks for the list guest!

[john]

thanks for all the answers to my question on cross ref for carbs. anybody wounder how much is involved in making a small rubber diaphragm? must be a job because the ones in my 78 400 kaw is a whopping $139. i need two so bought used carbs for $75. john

[quakeholio]

i'm not clear as to the diaphram that you're talking about, unless it's the air cut off valve or the acelerator pump. I think that the 1980-83 had these parts, if it's the 75-79 i have no idea. But then again i've never even gotten a good look at the out side of a gl carb. But i do have two 1980 model hondas, both on that list and they both have the parts i'm talking about.

If it is ether one just buy new ones, that aren't that pricey.

https://www.partsnmore.com/cat_index.ph ... egory=carb That's the page to look at. Not bad prices there ither.

[Try]

GL1100 Carb Diaphragm on ebay. This Set includes Diaphragm with Rod,
Bellow Rubber, Spring and O-Ring