Stock Seat becomes Custom, GL1100

Post your "How To", or share tips and tricks about maintenance related to four cylinder Wings. Only registered users can read this forum.

Moderators: Whiskerfish, Forum Moderators

Post Reply
User avatar
Roady
Member Relations &_Graphics
Member Relations &_Graphics
Posts: 11944
Joined: Wed Jun 20, 2007 2:35 pm
Location: Port St. John, FL

Re: Stock Seat becomes Custom, GL1100

#16

Post by Roady »

It is a touch firmer than it was. I did not remove any foam from the seating "sweet spot" just mostly from the sides and from the passenger area. If you look at the uncovered seat after cutting you can make out the original surface.

I added about an inch of foam under the driver portion to make it fit my long-ish legs better.
User avatar
Roady
Member Relations &_Graphics
Member Relations &_Graphics
Posts: 11944
Joined: Wed Jun 20, 2007 2:35 pm
Location: Port St. John, FL

Re: Stock Seat becomes Custom, GL1100

#17

Post by Roady »

Pictures restored in post #1.
Post Reply

Return to “How To 4-Wings (Tutorials Only)”