Page 1 of 1

How to replace the driveshaft

Posted: Fri May 23, 2008 5:16 pm
by kjeldbh
My bike is a GL1000 '77 with original mufflers.

Last year the union joint part of the drive shaft did break. I bought a new one and new cir clips from CMS:
http://www.cmsnl.com/honda-gl1000-gold- ... F++22.html

This is how the driveshafts looks:
Image

Next was to get the old one out and replace it with the new one. I had some trouble doing that, because I did follow the description from the shopmanual, which says that you have to remove the rear swing arm. I could not loosen the pivot bolts, and was looking for other ways, and managed to get the drive shaft out without removing the swing arm.

I removed the rear wheel and I removed the mufflers, too, which makes it possible to lower the swing arm so much, that I could pull the drive shaft out in the front end between the engine and the swing arm, an replace it with the new one.

The picture shows the new drive shaft on its way in place:
Image

From this I have learned, in order to prevent an unplanned replacement of the drive shaft, it is highly recommended to follow Randakks inspection guide :
http://www.randakksblog.com/driveshalf- ... nspection/

Regards Kjeld

Re: How to replace the driveshaft

Posted: Sat Jan 18, 2014 3:13 pm
by tlbranth
Can we get the pictures restored to this thread?

Re: How to replace the driveshaft

Posted: Sat Jan 18, 2014 5:11 pm
by Sagebrush
tlbranth wrote:Can we get the pictures restored to this thread?
Please read this thread: Gallery Upgrade Challenges

Re: How to replace the driveshaft

Posted: Sat Jan 18, 2014 5:12 pm
by Whiskerfish
fixed, his post was about 15 minutes before I made the announcement.

Re: How to replace the driveshaft

Posted: Fri Sep 19, 2014 3:19 pm
by SnoBrdr
Whiskerfish wrote:fixed, his post was about 15 minutes before I made the announcement.
So no pics? It's useless without them.