Been a minute since I updated. First off, minor change- gauge plan is COMPLETELY different. I've changed it up like three times since the last post, and I haven't locked it down yet, so we'll see.
Major update: the handlebars. I've never been completely happy with the fix I came up with for my handlebars. The hand location was pretty good, and the look was... okay. But the added pivoting riser solution was never very elegant, and always struck me as a bit of a bodge-job. Finding a good set of bars for this bike is nearly impossible (1" bar diameter coupled with a MONSTER pullback required), so for the time being I broke down and grabbed a set of stock bars.
I'm... not sure yet. The position is different, but I'm sure it'll be okay. It's fixed all the problems I had with the middle, but now I like the outer portions less. In any case, I'm going to ride it a while, see if it grows on me. Barring this, my only other viable option to getting me closer to a look I like (namely, lower and flatter) is a set of beach bars, but those are even wider than these. Not to mention the cost upwards of a couple hundred dollars- quite a stretch for a test.
I'll keep an eye out at swap meets for bars that may be better, but that's back burner for now. HOPEFULLY I can get the gauges and headlight figured out 100% this winter, so we'll see.
EDIT: Never mind, I hate it. I did one ride with them, but I'm REALLY not feeling it. They're too big, they're too wide, they ruin the lines of the bike, and I'm not a fan.
I think I'm going to try to mix up my old risers, but the old bars are definitely going back on eventually.