Note the gouges on the throttle plate. This is what I mean about using any tool around the throttle plate, such as wire or similar. It tears up the plate, giving air an extra avenue of access, reducing the effectiveness of the throttle to control airflow.
....from a set just got in this week...
Moderator: Whiskerfish
- mikenixon
- Early 'Wing Guru
- Posts: 997
- Joined: Thu Dec 10, 2009 1:51 am
- Location: Prescott, AZ
- Contact:
- Roady
- Member Relations &_Graphics
- Posts: 11957
- Joined: Wed Jun 20, 2007 2:35 pm
- Location: Port St. John, FL
Re: ....from a set just got in this week...
What a mess. I'm so glad that you pointed that out and supplied me with the correct info for the 1100 carb rebuild thread. Thanks again.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 10 Replies
- 629 Views
-
Last post by jdvorchak
-
- 5 Replies
- 3170 Views
-
Last post by heraldhamster