Stainless Steel Carb Clamps
Posted: Fri Nov 04, 2016 8:50 pm
I just bought new carb clamps for both of my bikes. It is easy to find stainless band clamps that are long enough but the ones I could find locally are all 1/2" wide where the originals are 8 or 9 mm wide and have to fit in grooves in the rubber that are about 10mm wide. Honda specifies different sizes for the CX's inlet & outlet and for the GoldWing but they are all between 55 and 59mm (can't remember which is which off hand, which is why I mentioned the CX).
Someone on cx500forum.com found Norma Torro (also known as Awab Torro) clamps that are 9mm wide.
You want part #NT09060-W4 (40-60mm). They should be less than $2 each. I found them at this site but if you aren't in Canada you should probably look for them at a marine supplier closer to home.
I have installed them on the 650 and they look way better than the originals.
Someone on cx500forum.com found Norma Torro (also known as Awab Torro) clamps that are 9mm wide.
You want part #NT09060-W4 (40-60mm). They should be less than $2 each. I found them at this site but if you aren't in Canada you should probably look for them at a marine supplier closer to home.
I have installed them on the 650 and they look way better than the originals.