Check out this guys bike:
https://www.youtube.com/watch?v=UhuGyS0_-IY
He obviously did it on the cheap, but it seems to start right up and run good.
I find the whole idea of 3D printed intake manifolds intriguing. Especially for one off applications like this.
dual Weber custom
Moderators: sunnbobb, Neil, Forum Moderators
- dontwantapickle
- Silver Member
- Posts: 946
- Joined: Fri Oct 13, 2017 9:26 pm
- Location: Colorado
- codyjames707
- Billet Alum. Member
- Posts: 299
- Joined: Wed May 14, 2014 3:53 pm
- Location: Vallejo, CA
Re: dual Weber custom
WOW, that guy has done an INSANE amount of custom work done. Could hardly recognize it as a GoldWing!
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 734 Views
-
Last post by Spanky
-
- 22 Replies
- 4341 Views
-
Last post by sunnbobb
-
- 8 Replies
- 920 Views
-
Last post by gregforesi