New service provided by Rob's Motorcycle Repair

[robin1731]

Some of you have looked at my post about vapor blasting. Look here if you have not. viewtopic.php?f=9&t=72870

I have decided to offer Vapor Blasting service. I can do smaller parts. Mostly carburetor parts. If you have never seen what this does it is pretty amazing. After the parts come out they are very smooth. Look almost new. Almost seem to be painted.

Vapor blasting uses water mixed with very fine glass beads to create this finish. Similar to a bead/sand blast cabinet. The setup I have uses air only to operate. Below are some pics of some finished parts and some parts that have only half of them done to show how it looks when complete. They look and feel better than the pictures can show.

The cost for this service for NGW club members is $50.00 per hour. That is for the vapor blasting only. Any disassembly or assembly would be extra. If you have parts you want done contact me via pm. If they are larger parts check with me and I'll see if there is room.

[robin1731]

These are pics of some completed parts.

[robin1731]

I will be adding this to my listing in the for sale section. viewtopic.php?f=6&t=65300

[Lucien Harpress]

No lie, I've had my eye on getting this done (assuming I can get the carb working) at some point. It's definitely intriguing.

[Whiskerfish]

[Gowing]

I’ve noticed this on parts for sale and couldn’t figure out how and why the parts looked so nice.
Now I see how they did it. Truly amazing outcomes.