Rear master cylinder

Discuss everything about Honda GoldWing. Feel free to ask any question related to GoldWing.

Moderators: CYBORG, Oldewing, robin1731, Forum Moderators

Post Reply
Edmaddox
Cast Iron Member
Cast Iron Member
Posts: 65
Joined: Tue Jul 05, 2016 6:46 am

Rear master cylinder

#1

Post by Edmaddox »

I am currently trying to restore a 1980 Goldwing interstate. Going along pretty good until I got to the rear master cylinder, put a rebuild kit in it but it was leaking out the boot so took it back a part and noticed some pitting in the neck near the end so toot some Emeries paper on a stick with a drill to dress it up. Must have taken too much off because now it will not build up any pressure. Having a tough time finding a replacement. Any ideas?
Top
User avatar
ericheath
Honored Life Member
Honored Life Member
Posts: 9583
Joined: Wed Jul 29, 2009 11:20 am
Location: Winnipeg, Manituba

Re: Rear master cylinder

#2

Post by ericheath »

Several have adapted more readily available gl1800 rear masters with a little modification.

http://www.ngwclub.com/forum/viewtopic. ... 00#p580379
Whatever I suggest here should be given ample time for a moderator to delicately correct. I apologize in advance.
77 WING, 1200 engine with 77 heads, cams, gl1100 foot pegs, Magna V65 front end, 764A carbs, [-gone Suzuki M109 monoshock--, replaced with gl1100 shocks] gl 1200 swing arm, gl1500 final drive, wheel and rear brakes Valkyrie seat, Meanstreak tank, Sportster pipes, Power Arc ignition off crank.
77 Wing. black
83 Wing, in pieces
"Continuing education is important even if the subject matter is fairly useless (as in this case)."---Greg Foresi
Top
Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “GoldWing Tech Discussions”