Here is a picture of how the GL1200 EFI setup works. This is on the EFI motors, not the carbed. However, I bought mine on ebay for only a few bucks.
Water pump with extra host nipple
Thermostat housing with extra sensors and hose nipple.
They bolt right on with a small tab that you need to cut off the top of the motor (it's only for lifting and wasn't on the fuel injected models)
Critique my manifold heating!
Moderators: sunnbobb, Neil, Forum Moderators
- Toehead
- True Blue Steel Biker
- Posts: 2139
- Joined: Fri Jul 15, 2011 3:10 pm
- Location: Mendon, MA
Re: Critique my manifold heating!
Last edited by Toehead on Sat Jan 07, 2017 7:54 pm, edited 2 times in total.
2012 Golf TDI, fast and frugal oil burner
1980 CX500C, All around road warrior (Sold)
1975 TS125 (Sold), old smoker
1977 naked GL1000, Highway cruiser
'81 GL1100 14,000 (reconditioned and sold)
'81 GL1100 50,000 miles (under construction)
2X 1981 CM400 beginner bike (sold)
1980 CB750C (sold)
1994 Virago 750 (Wifey's bike)
'76 GL1000 Sulphur Yellow (Megasquirted efi build) http://www.ngwclub.com/forum/viewtopic.php?f=47&t=59774
1980 CX500C, All around road warrior (Sold)
1975 TS125 (Sold), old smoker
1977 naked GL1000, Highway cruiser
'81 GL1100 14,000 (reconditioned and sold)
'81 GL1100 50,000 miles (under construction)
2X 1981 CM400 beginner bike (sold)
1980 CB750C (sold)
1994 Virago 750 (Wifey's bike)
'76 GL1000 Sulphur Yellow (Megasquirted efi build) http://www.ngwclub.com/forum/viewtopic.php?f=47&t=59774
- Oldboy
- Silver Member
- Posts: 697
- Joined: Sat Jul 26, 2008 4:53 pm
- Location: Mississauga Ontario Canada
Re: Critique my manifold heating!
Toehead is right...that's exactly what I did to mine. I drilled & taped both housings using 1/8" pipe thread
fittings. (I didn't know 1200's had this). I also plugged the original bypass port (in the water pump housing).
This forced all the coolant through my intake heater during warm up.
fittings. (I didn't know 1200's had this). I also plugged the original bypass port (in the water pump housing).
This forced all the coolant through my intake heater during warm up.
Cheers...
Just Wing-it
Just Wing-it
- ericheath
- Honored Life Member
- Posts: 9580
- Joined: Wed Jul 29, 2009 11:20 am
- Location: Winnipeg, Manituba
Re: Critique my manifold heating!
Fuzzy head is telling me it was only 1200 efi models which had this. One of mine has this (efi) the other does not.
Whatever I suggest here should be given ample time for a moderator to delicately correct. I apologize in advance.
77 WING, 1200 engine with 77 heads, cams, gl1100 foot pegs, Magna V65 front end, 764A carbs, [-gone Suzuki M109 monoshock--, replaced with gl1100 shocks] gl 1200 swing arm, gl1500 final drive, wheel and rear brakes Valkyrie seat, Meanstreak tank, Sportster pipes, Power Arc ignition off crank.
77 Wing. black
83 Wing, in pieces
"Continuing education is important even if the subject matter is fairly useless (as in this case)."---Greg Foresi
77 WING, 1200 engine with 77 heads, cams, gl1100 foot pegs, Magna V65 front end, 764A carbs, [-gone Suzuki M109 monoshock--, replaced with gl1100 shocks] gl 1200 swing arm, gl1500 final drive, wheel and rear brakes Valkyrie seat, Meanstreak tank, Sportster pipes, Power Arc ignition off crank.
77 Wing. black
83 Wing, in pieces
"Continuing education is important even if the subject matter is fairly useless (as in this case)."---Greg Foresi
- Toehead
- True Blue Steel Biker
- Posts: 2139
- Joined: Fri Jul 15, 2011 3:10 pm
- Location: Mendon, MA
Re: Critique my manifold heating!
Yes, that's correct. I'll edit my post.
2012 Golf TDI, fast and frugal oil burner
1980 CX500C, All around road warrior (Sold)
1975 TS125 (Sold), old smoker
1977 naked GL1000, Highway cruiser
'81 GL1100 14,000 (reconditioned and sold)
'81 GL1100 50,000 miles (under construction)
2X 1981 CM400 beginner bike (sold)
1980 CB750C (sold)
1994 Virago 750 (Wifey's bike)
'76 GL1000 Sulphur Yellow (Megasquirted efi build) http://www.ngwclub.com/forum/viewtopic.php?f=47&t=59774
1980 CX500C, All around road warrior (Sold)
1975 TS125 (Sold), old smoker
1977 naked GL1000, Highway cruiser
'81 GL1100 14,000 (reconditioned and sold)
'81 GL1100 50,000 miles (under construction)
2X 1981 CM400 beginner bike (sold)
1980 CB750C (sold)
1994 Virago 750 (Wifey's bike)
'76 GL1000 Sulphur Yellow (Megasquirted efi build) http://www.ngwclub.com/forum/viewtopic.php?f=47&t=59774
-
- Similar Topics
- Replies
- Views
- Last post
-
- 24 Replies
- 837 Views
-
Last post by Whiskerfish
-
- 15 Replies
- 467 Views
-
Last post by olchris
-
- 6 Replies
- 380 Views
-
Last post by pjlogue
-
- 25 Replies
- 1669 Views
-
Last post by 5speed
-
- 37 Replies
- 551 Views
-
Last post by overboostin